1. Enter fence length, height, and spacing
Add the total run in feet, the fence height, and post spacing (8 ft is standard). Adjust picket width and gap to match your lumber.
Plan a wood privacy fence from total length and height: post count at your spacing, picket count with gap and waste, rails per section, concrete bags per post, and a full materials cost estimate with adjustable unit prices.
Add the total run in feet, the fence height, and post spacing (8 ft is standard). Adjust picket width and gap to match your lumber.
See post count, picket count with waste, rails per section, and concrete bags per post — all calculated instantly.
Adjust unit prices to your local store and copy the full materials list for shopping or contractor quotes.
Fence layout
Unit prices ($)
13 sections · pickets include 5% waste · concrete in 50-lb bags, 1–2 bags per post is typical
Pro tip — space posts evenly
Posts every 8 ft leave a short 4 ft bay at the end. Instead, mark holes at 7 ft 8 in apart — same materials, but the fence looks planned instead of fitted.
What's next?
Keep the project moving — your numbers carry over automatically.
Post count is the fence length divided by post spacing, rounded down, plus one for the final end post. Picket count is the total length in inches divided by picket width plus gap, plus 5–10% waste for cuts and defects. Rails run horizontally between posts: use 2 rails per section for fences up to 6 feet and 3 rails for taller fences or heavy pickets.
Set posts one-third of their length underground with at least 2 feet of embedment, deeper than the local frost line in cold climates. A 4×4 post in a 12-inch hole 30 inches deep needs about 1.5 fifty-pound bags of concrete. Bell out the bottom of the hole slightly so frost cannot push the footing upward.
Cedar costs roughly 30–50% more than pressure-treated pine but resists rot and insects longer without chemical treatment. In 2026, professionally installed wood privacy fences run about $25–$45 per linear foot; DIY material costs are roughly half that. Gates, slopes, and old-fence removal add the most to a quote.
Eight feet on-center is standard for wood privacy fences. Use 6-foot spacing in high-wind areas, for fences over 6 feet tall, or around heavy gates that stress the posts.
Most 4×4 posts set in a 10–12 inch diameter hole need 1 to 2 fifty-pound bags of fast-setting concrete. Bury one-third of the post length, with a minimum of 2 feet in the ground.
For privacy fences, leave 0 to 1/4 inch so boards can expand without buckling. In windy areas a 1/2-inch shadowbox gap reduces wind load while keeping privacy from most angles.
Cedar lasts 15–20 years and pressure-treated pine 10–15 years with basic maintenance: keep boards off the soil, seal or stain every 2–3 years, and replace damaged pickets promptly.
Yes. Marking posts every 8 ft often leaves a short bay at the end that looks like an afterthought. Divide the run by the number of sections instead — the calculator above shows this even spacing and warns you when the last bay would come up short.
Yes. Click “Add to list” on your result to collect it in a project list (bottom-right button on every DIY page). Name the project, add a note per item, and download the whole list as a PDF to take to the store.