1. Enter total rise
Measure floor to top of landing in inches — the single number everything derives from.
Cut perfect stair stringers: step count from total rise within code limits, exact riser height and tread depth, stringer length by the Pythagorean theorem, and the 2×12 boards to buy — with an IRC code check on every layout.
Measure floor to top of landing in inches — the single number everything derives from.
See riser count and height, tread count and depth, stringer length, and the 2×12 boards to buy.
Copy risers, runs, and board lengths for the lumberyard and the job site.
Total run 3.67 ft · stair angle 39.3° · stringer = √(rise² + run²)
Meets IRC code
Riser ≤ 7¾″ and tread ≥ 10″. Comfort check 2R+T = 25.4″ — outside the 24–25″ comfort zone; adjust tread depth if the climb feels steep.
What's next?
Keep the project moving — your numbers carry over automatically.
Divide total rise by the max riser height (7.75″) and round up for the riser count, then divide total rise by that count for the exact riser height. Equal risers aren't just code — uneven steps are a trip hazard you feel in the dark.
Total run is (risers − 1) × tread depth. Stringer length is √(rise² + run²) — the hypotenuse of the whole staircase. Buy boards at least this long; the calculator rounds up to standard 8/10/12/16-ft lumber.
Carpenters aim for 2 × riser + tread between 24 and 25 inches. A 7.5″ riser with an 11″ tread hits 26″ — slightly steep but common outdoors; 7″ + 11″ is the sweet spot for interior stairs.
The IRC limits risers to 7¾ inches maximum, with treads at least 10 inches deep. This calculator caps the riser count math at your max riser height and flags any layout that breaks code.
It depends on the stringer length, not the step count — one board makes one stringer. A 12-ft 2×12 covers stringers up to 12 ft; this calculator picks the shortest standard board (8, 10, 12, or 16 ft) that fits your stringer.
A staircase with N risers has N−1 treads cut into the stringer — the top tread is the landing or deck surface itself. The calculator accounts for this automatically.
Use the “What's next” card below your result — your total rise carries over to the stair calculator for the full layout with total run and code checks.