UtilFlow

Home Insulation Calculator

Size a home insulation project: attic, wall, or floor area and insulation type (fiberglass or mineral wool batts, blown-in cellulose/fiberglass, rigid foam board) to pack, bag, or board counts with target R-values and cost.

1. Pick the location

Attic, exterior wall, or floor — each shows its recommended R-value range.

2. Choose material and area

Batts, blown-in, or foam board; enter length and width, and check the coverage per pack or bag.

3. Get quantity and cost

Packs, bags, or boards with waste included, plus a cost estimate.

Blown-in is the usual pick — aim for 12–15″ deep.

Your estimate
22
bags needed
600
sq ft to cover
R-38 to R-60
target R-value
$308
est. cost

10% waste/overfill included · blown-in coverage varies by depth — always check the bag chart for your target R-value

Related tools

Useful next steps

R-value is about thickness

Every insulation material has an R-value per inch (fiberglass ~3.2, cellulose ~3.7, closed-cell foam ~6.5). Target R ÷ per-inch R = inches needed. That's why attics need a foot or more of blown-in — there's no shortcut around depth.

The bag chart is the truth

Blown-in coverage per bag drops as target R rises — the same bag covers more square feet at R-30 than at R-49. Always read the chart on the bag for your exact target R; the calculator's defaults are starting points, the bag chart wins.

Air seal before you insulate

Insulation slows heat flow; it doesn't stop air leaks. Sealing attic bypasses (plumbing stacks, wire penetrations, top plates) with caulk or foam before blowing insulation can matter as much as the insulation itself — and it's cheap.

Home Insulation Calculator FAQ

What R-value does my attic need?

Most US climates want R-38 to R-60 in the attic — roughly 12–15 inches of blown-in cellulose or fiberglass. Walls typically need R-13 to R-21, floors R-25 to R-30. This calculator shows the target range for each location.

How many bags of blown-in insulation for an attic?

Divide attic square footage by the bag's coverage at your target R-value (printed on the bag chart — about 30 sq ft per bag of cellulose at R-38). A 600 sq ft attic needs roughly 20 bags plus 10% overfill, which is the math this calculator uses.

Batts or blown-in insulation?

Blown-in wins for attics: it fills gaps around joists, wires, and pipes with no cutting. Batts suit open wall cavities and floors between joists. Blown-in also makes it easy to top up an under-insulated attic without removing anything.

Can I add insulation over what's already there?

Usually yes — topping up an attic from R-19 to R-38 is one of the highest-ROI home projects. Don't compress batts (compression kills R-value), keep soffit vents clear with baffles, and never cover recessed lights not rated for contact.

Can I save this estimate?

Yes. The “Add to list” button saves the area, material, quantity, and cost to your project list — stored in your browser, printable and exportable as PDF.