1. Enter floor-to-floor height
Measure from finished floor to finished floor in inches.
Layout any staircase from floor-to-floor height: step count, exact riser height, tread count, total run, and stair angle — with IRC code checks and the 2R+T comfort rule on every layout.
Measure from finished floor to finished floor in inches.
See riser count and height, total run, stair angle, and whether the layout meets code.
Copy the full layout for planning, permits, or your carpenter.
Meets IRC code
Riser ≤ 7¾″ and tread ≥ 10″. Comfort rule 2R+T = 26.4″ — outside the 24–25″ comfort zone; deepen the tread if the stair feels steep.
Make sure you have 11.9 ft of clear floor space for the run, plus 80″ of headroom above every tread nosing.
What's next?
Keep the project moving — your numbers carry over automatically.
Always lay out the staircase on paper first: risers, exact riser height, tread count, and total run. Discovering the run doesn't fit after the stringers are cut is the classic DIY stair mistake.
IRC: risers ≤ 7¾″, treads ≥ 10″, and at least 80″ of headroom above every tread nosing. Risers can't vary more than ⅜″ across a flight — the calculator keeps them mathematically equal.
Long runs need a landing: IRC requires one every 12 feet of vertical rise. A landing also breaks a straight run into two flights, which is often the only way a stair fits the floor plan.
Divide your floor-to-floor height by the max riser height (7.75″) and round up — that riser count gives you the exact riser height. A 108-inch floor-to-floor needs 14 risers at 7.71 inches each.
Total run is (risers − 1) × tread depth. A 14-riser stair with 11-inch treads needs about 12 feet of run — the calculator shows this so you can check it fits before you build.
Twice the riser plus the tread should land between 24 and 25 inches for a comfortable climb. The calculator checks this on every layout and tells you when a stair will feel steep.
Use the “What's next” card below your result — your total rise carries over to the stair stringer calculator for the cut list and board lengths.