UtilFlow

Stair Calculator

Layout any staircase from floor-to-floor height: step count, exact riser height, tread count, total run, and stair angle — with IRC code checks and the 2R+T comfort rule on every layout.

1. Enter floor-to-floor height

Measure from finished floor to finished floor in inches.

2. Review steps, run, and code

See riser count and height, total run, stair angle, and whether the layout meets code.

3. Copy the layout

Copy the full layout for planning, permits, or your carpenter.

Stair layout
14
risers @ 7.71 in
13
treads @ 11 in
11.92
ft total run
37.1°
stair angle

Meets IRC code

Riser ≤ 7¾″ and tread ≥ 10″. Comfort rule 2R+T = 26.4″ — outside the 24–25″ comfort zone; deepen the tread if the stair feels steep.

Make sure you have 11.9 ft of clear floor space for the run, plus 80″ of headroom above every tread nosing.

What's next?

Keep the project moving — your numbers carry over automatically.

Related tools

Useful next steps

Layout before lumber

Always lay out the staircase on paper first: risers, exact riser height, tread count, and total run. Discovering the run doesn't fit after the stringers are cut is the classic DIY stair mistake.

Code minimums

IRC: risers ≤ 7¾″, treads ≥ 10″, and at least 80″ of headroom above every tread nosing. Risers can't vary more than ⅜″ across a flight — the calculator keeps them mathematically equal.

Landings

Long runs need a landing: IRC requires one every 12 feet of vertical rise. A landing also breaks a straight run into two flights, which is often the only way a stair fits the floor plan.

Stair Calculator FAQ

How many steps do I need?

Divide your floor-to-floor height by the max riser height (7.75″) and round up — that riser count gives you the exact riser height. A 108-inch floor-to-floor needs 14 risers at 7.71 inches each.

How much floor space does a staircase need?

Total run is (risers − 1) × tread depth. A 14-riser stair with 11-inch treads needs about 12 feet of run — the calculator shows this so you can check it fits before you build.

What is the 2R+T rule?

Twice the riser plus the tread should land between 24 and 25 inches for a comfortable climb. The calculator checks this on every layout and tells you when a stair will feel steep.

How do I go from layout to cutting stringers?

Use the “What's next” card below your result — your total rise carries over to the stair stringer calculator for the cut list and board lengths.